Water Fill; Brew Strength - Russell Hobbs 13406 Instructions Manual

water fill

4 Use the carafe to fill the reservoir, to avoid overfilling.
5 Remove the carafe from the hotplate.
6 Pull the lever back towards the handle, to open the carafe.
7 Use the grip to open the coffee maker lid, to expose the reservoir, the filter holder,
and the filter.
8 Fill the reservoir with at least 2 cups of water, but don't fill above the max mark. If
you overfill, excess water will escape from the overflow at the rear of the coffee
maker.
9 Close the carafe lid, and sit the carafe on the hotplate.
coffee fill
10 Put filter-ground coffee into the filter. The amount will vary with the type of coffee,
and individual taste, but we suggest starting with one scoop per cup of water.
11 Use the grip to close the coffee maker lid – it must cover the filter holder and the
reservoir before you power up the coffee maker.

brew strength

12 Turn the brew strength control (on top of the lid) anti-clockwise to strengthen the
brew, clockwise to lighten the brew.
13 It works by diverting some of the water past the coffee grounds.
power up
14 Plug the coffee maker into the power socket (switch the socket on, if it's switchable).
15 The display will show 0:00, flashing.
coffee now
16 To make coffee right away:
a) ignore the display
b) press the [ button, the [ light will come on
c) after a few seconds, coffee will drip into the carafe
coffee later
17 If you want to use the timer to make coffee later:
set the time now
a) Press and release the h (hour) and min (minute) buttons to set the display to the
correct time
b) AM or PM will show at the side of the display – check you've got the right one
set the brewing time
c) press the T button, and keep it pressed while you set the brewing time
d) press and release the h (hour) and min (minute) buttons to set the display to the
time you want the coffee maker to start brewing
e) AM or PM will show at the bottom of the display – check you've got the right one
f) release the T button – the display will revert to the correct time
g) now press and release the AUTO button to activate the timer – the AUTO light
will come on, and AUTO will appear in the display,
h) at the time you set, the AUTO light will go out, AUTO will disappear from the
screen, the [ light will come on, and the coffee maker will start up
4