Cisco 3200 Series Hardware Reference Manual page 26

To attach the protective end cap cover to the enclosure, follow these steps (see
Figure 1-10
1
Hinge bracket
3
Cable/service loop cavity
5
Gasket
Loosen the end cap mounting hardware (four 1/4-20 bolts), but do not remove the bolts.
Step 1
Slide the hinge brackets onto the right side and the left side of the end cap cover. The mounting tabs
Step 2
should slide under the loosened bolts.
Re-torque the two loosened bolts on the right side of the end cap cover to between 58 and 68 in-lb.
Step 3
Ensure that the gasket is fully seated in the protective end cap cover.
Step 4
Close the cover on the protective end cap cover and ensure that it is fully seated.
Step 5
Step 6 Re-torque the end cap cover bolts on left side of the end cap cover to between 58 and 68 in-lb.
Step 7 Tighten the 8-32 protective cover screws (18 in-lb) until they are seated.
For sealing, we recommend Liquid Tight Connector, which is described at the following URL:
http://www.newark.com/NewarkWebCommerce/newark/en_US/mfr/brands.jsp?mfg=HUBB
Cisco 3200 Series Router Hardware Reference
1-14
Protective End Cap Cover Installation
2
6
5
4
3
Chapter 1
1
2
Hinge point
4
NEC pass-through
6
Cap mounting
Cisco 3200 Rugged Enclosures
Figure 1-10).
OL-5816-10