Operation; Recording A Phrase; Clearing A Phrase - DigiTech JamMan Express XT Owner's Manual

Operation

The JamMan Express XT was designed to be very simple to use right out of the box� This
section of the manual describes how to perform the basic looping functions�

Recording a Phrase

The JamMan Express XT records a single phrase and then plays it back as a continuous loop�
To record a phrase:
1� Press the
FOOTSWITCH
solid red and recording will begin�
2� When finished recording, press the
phrase will automatically begin playing back in a repeating loop and the
light solid green�
3� Press the
FOOTSWITCH
NOTE: The maximum phrase recording length is 10 minutes�

Clearing a Phrase

Clear a phrase to re-record it or record a new phrase� The JamMan Express XT has a
unique feature, referred to as "Silent Clear
to play it first� Note that you cannot undo the process of clearing a phrase, so make sure
you want to proceed before performing this function�
To clear a recorded phrase:
1� Stop loop playback if it is not already (all LEDs should be off)� If loop playback is active
(the
PLAY LED
2� Press and hold the
indicating the phrase has been cleared�
NOTE: When using a slave/master looper setup, if the master loop is ~3 seconds or less
and if pressing and holding the
clear on the slave device, you may need to initiate play then stop (3
presses) and hold the footswitch on the 3rd press to clear its loop�
6
and begin playing to start recording� The
2 times quickly to stop loop playback�
is on), press the
FOOTSWITCH
FOOTSWITCH
FOOTSWITCH
once to set the loop end point� The
FOOTSWITCH
™
", which clears a phrase without requiring you
2 times to stop loop playback�
for ~2 seconds� The
from a stopped state does not initiate
REC LED
PLAY LED
will quickly flash red,
REC LED
FOOTSWITCH
will light
will