Technical Information - DigiTech Element Owner's Manual

Technical Information

Factory Restore
The Factory Restore procedure will return the Element/Element XP to its factory default state.
WARNING! The Factory Restore procedure will reset all modified user presets and return them to
their factory default settings. This procedure is permanent and cannot be undone.
To perform the Factory Restore procedure:
Start with the power cable disconnected (unit powered down).
1.
Press and hold the
2.
display, release the
seconds until
rSt
The Factory Restore procedure will be performed. Wait for it to finish. At this point the
3.
Factory Restore procedure will be complete if using an Element. When resetting an Element
XP, you must proceed to step 4 to calibrate the Expression Pedal.
When appears in the display (Element XP only), the Element XP's Expression Pedal is
4.
tdn
ready to be calibrated. Rock the
.
FOOTSWITCH
When appears in the display, rock the
5.
tuP
either
FOOTSWITCH
If the calibration procedure is successful, the Element XP will return to Play Mode and will be
6.
ready for use. If the calibration procedure fails,
. If this happens, repeat steps 4 and 5 until calibration is successful.
tdn
34
button while connecting the power cable. When
STORE
button then quickly press and hold the
STORE
appears in the LED display then release.
EXPRESSION PEDAL
.
forward (toe down) then press either
EXPRESSION PEDAL
will appear in the LED display followed by
Err
appears in the
Fr
button again for 3
STORE
back (toe up) then press