Expression Pedal Calibration (Element Xp Only) - DigiTech Element Owner's Manual

Speaker Cabinet Compensation is now enabled on all outputs.
NOTE: Once enabled, SCC will remain active only while the unit is powered on. After a power cycle,
the SCC enabling procedure must be performed again if you want SCC to be enabled.

Expression Pedal Calibration (Element XP Only)

The Expression Pedal on the Element XP comes pre-calibrated from the factory. However, in the
event the Expression Pedal does not function properly, it can be re-calibrated using the below
Pedal Calibration procedure.
To calibrate the Element XP Expression Pedal:
Press and hold both
1.
effects and button LEDs will be turned off.
When appears in the display, rock the
2.
tdn
press either
FOOTSWITCH
When appears in the display, rock the
3.
tuP
either
FOOTSWITCH
If the calibration procedure is successful, the Element XP will return to Play Mode and will be
4.
ready for use. If the calibration procedure fails,
. If this happens, repeat steps 2 and 3 until calibration is successful.
tdn
22
simultaneously until
FOOTSWITCHES
.
.
appears in the LED display. All
PC
EXPRESSION PEDAL
EXPRESSION PEDAL
will appear in the LED display followed by
Err
forward (toe down) then
back (toe up) then press