NETGEAR ProSafe WG102-500 Reference Manual page 59

WG102-500, WGAP150 ProSafe™ 802.11g Wireless Access Point
2. Select Configuration > Wireless Networks. The Wireless Networks screen opens,
displaying 16 wireless security profiles (see
3. To configure or edit a wireless security profile, select the corresponding Edit hyperlink to the
right of the wireless security profile. The Edit Wireless Network screen opens for the
selected wireless security profile. Scroll down to the Alternative Layer 2 Communication
Settings section.
4. Select the Alternative Layer 2 Communication Enabled checkbox. The screen expands to
let you configure the wireless client separation settings.
Figure 3-19
5. Enter the wireless client separation settings (also referred to as alternate Layer 2
communication settings) as explained in
Table 3-11. Wireless Client Separation Settings
Field
Separate Unicast Packets
Separate
Broadcast/Multicast
packets
Separate between SSIDs
6. Click Save or Save to Flash & Activate to save your settings.
Table
Descriptions
By default, unicast packets are blocked between clients of the SSID.
Deselect the Enabled checkbox to allow unicast packets between clients
of the SSID.
By default, broadcast and multicast packets are blocked between clients
of the SSID. Deselect the Enabled checkbox to allow broadcast and
multicast packets between clients of the SSID.
By default, communication between clients of the SSID and clients of
other SSIDs is blocked. Deselect the Enabled checkbox to allow
communication between clients of the SSID and clients of other SSIDs.
Figure 3-2 on page 38).
3-11.
| 59