Playing Back Tapes (On Either Deck A Or B) - Sony HCD-461 Operating Instructions Manual

Playing Back Tapes (on either Deck A or B)

This section describes basic playback from either deck A or B.
SYSTEM POWER
n ON
4 2
1
Press TAPE.
VIDEO 1/MD
VIDEO 2 TAPE
"TAPE" appears on the display.
2
Press § to open the cassette compartment,
insert the tape with the side to be played
facing you and close the cassette
compartment.
DECK A
0 )
1 3
P
p
2
4
CD TUNER PHONO
EJECT
§
3
Press DOLBY NR to select the DOLBY NR
setting.
DOLBY NR
Ø ON ø OFF
4
Press · to start playback.
When the tape ends, playback stops automatically.
To stop playback, rewinding or fast forwarding,
press p.
To pause, press P.
To resume playback, press P again or ·.
To rewind the tape, press 0.
To fast-forward the tape, press ).
Notes
• During playback or recording on one deck, do not operate
the other deck. (When both decks A and B are in playback
mode, only playback from deck A will be audible.)
• Before turning the power off, be sure to stop playback or
recording by pressing p.
What is the Dolby NR* system?
Dolby NR (noise reduction) system reduces tape hiss noise in
low-level, high-frequency signals. The system boosts these
signals in recording and lowers them in playback.
When listening to a tape recorded with Dolby NR, set
DOLBY NR to ON.
* Dolby noise reduction manufactured under license from Dolby
Laboratories Licensing Corporation.
"DOLBY" and the double-D symbol a are trademarks of Dolby
Laboratories Licensing Corporation.
·
15