Setting Up The Shredder; Using The Shredder - Dynex DX-PS06CC User Manual

6

Setting up the shredder

Warning: Crosscut shredders have very sharp exposed blades on the underside. Use care
Caution: The shredder should not be plugged in during assembly.
Note: The following illustrations are for information purposes only. Your actual shredder may
To set up the shredder:
1
Position the shredder head over the basket.
2
Place the shredder head on the basket so that it solidly rests on the basket edges.
Note: Always make sure that these two labels are aligned on the same side of the shredder

Using the shredder

Note: Prepare paper to be shredded by removing staples and paper clips from the paper.
To use the shredder:
Caution:
when mounting the shredder on the wastebasket.
look somewhat different than the shredder shown.
when you place the shredder head onto the basket. This shredder has a safety interlock
which prevents it from operating unless the shredder head is placed on the basket
correctly.
Make sure that each batch of paper does not exceed the recommended capacity of six
sheets.
• Do not overfeed the shredder: Shredding beyond the specified sheet capacity can
result in extensive damage to the shredder. Overfeeding will strain the machine and
quickly wear and break the cutting blades and internal components.
DX-PS06CC