Configuring The Standard Tcp/Ip Port; Printer Driver Not Yet Installed - Brother TD-series User Manual

Td series multi-protocol on-board ethernet print server
Hide thumbs Also See for TD-series:
Table of Contents

Advertisement

Configuring the standard TCP/IP port

Printer driver not yet installed

®
For Windows Vista
, Windows
a
®
For Windows Vista
Click the
(Windows Vista
Sound and open Printers.
®
For Windows
7/ Windows Server
Click the
(Windows
b
Click Add a printer.
c
Choose Add a local printer.
d
You must now choose the correct Network printing port. Choose Create a new port and choose
Standard TCP/IP Port from the pull-down window, then click Next.
e
Enter the IP address, or the print server name you wish to configure. The Wizard will automatically enter
the Port name information for you, then click Next.
®
f
Windows Vista
, Windows
specified. If you did not specify the correct IP address or name then an error dialog will appear.
g
Now that you have configured the port, you must specify which printer driver you wish to use. Choose
the appropriate driver from the list of supported printers. If you are using a driver supplied with the printer
on CD-ROM then choose the Have Disk option to browse to the CD-ROM.
h
For example, choose the "X:\your language\Drivers\TD-XXXX\x86\Driver\i386" or
"X:\your language\Drivers\TD-XXXX\x64\Driver\x64" folder (where X is your drive letter. XXX is your
model name). Click Open, and then OK. Choose your printer model, then click Next.
i
Specify a name and click Next.
Note
• When the User Account Control screen appears, click Continue.
• If the printer driver that you are installing does not have a Digital Certificate you will see a warning
message. Click Install this driver software anyway to continue with the installation.
j
Continue through the Wizard clicking Finish when complete.
®
7, Windows Server
®
/ Windows Server
2008:
®
)/ Start (Windows Server
®
2008 R2:
®
7)/ Start (Windows Server
®
®
7 and Windows
Network printing: basic TCP/IP Peer-to-Peer printing
®
2008/2008 R2
®
2008), Control Panel, go to Hardware and
®
2008 R2), and open Devices and Printers.
2008/2008 R2 will now contact the printer that you
3
3
3
3
15

Advertisement

Table of Contents
loading

This manual is also suitable for:

Td-4100nNc-13004h

Table of Contents