Assembly - Healthrider HRSY54370 User Manual

ASSEMBLY

Before beginning assembly, carefully read the
following information and instructions:
¥ Place all parts of the home gym system in a
cleared area and remove the packing materials;
do not dispose of the packing materials until
assembly is completed.
¥ For help identifying the small parts used in
assembly, use the PART IDENTIFICATION
CHART located in the center of this manual.
Note: Some small parts may have been pre-
attached for shipping. If a part is not in the parts
bag, check to see if it has been pre-attached.
¥ As you assemble the home gym system, be sure
that all parts are oriented as shown in the
drawings.
1. Before beginning assembly, be sure that you
have read and understand the information in the
box above.
Insert four 3/8Ó x 2 1/2Ó Carriage Bolts (60) up
through the Base (1). Note: It may be helpful to
tape the Carriage Bolt heads in place under the
Base. If you do tape the Carriage Bolt heads,
remove the tape once you finish assembly.
¥ Tighten all parts as you assemble them, unless
instructed to do otherwise.
THE FOLLOWING TOOLS (NOT INCLUDED) ARE
REQUIRED FOR ASSEMBLY:
¥ Two (2) adjustable wrenches
¥ One (1) phillips screwdriver
¥ One (1) rubber mallet
¥ Lubricant, such as grease or petroleum jelly,
and soapy water will also be needed.
Assembly will be more convenient if you have the
following tools: A socket set, a set of open-end or
closed-end wrenches, or a set of ratchet wrenches.
1
60
5
1
60