Table of Contents
Advertisement
ASSEMBLY
Before beginning assembly, carefully read the
following information and instructions:
• Place all parts in a cleared area and remove the
packing materials; do not dispose of the packing
materials until assembly is completed.
1. Attach the Handlebar (6) to the Handlebar Swing
Arm (5) by depressing the Dual End Snap Button
(46) and inserting the Handlebar into the Handlebar
Swing Arm. Make sure that the Dual End Snap
Button seats fully into the indicated holes in the
Handlebar Swing Arm.
2. Press the Magnet w/Bracket (36) onto the Pedal
Frame (4) as shown.
Slide the Monitor (35) fully onto the Main Frame (1)
as shown in inset drawing A. Press down on the
Monitor as shown in inset drawing B until it snaps
into place.
3. Remove the battery cover from the Monitor (35).
Insert two new AA batteries into the Monitor. Identify
the negative (–) and positive (+) ends of the batter-
ies. The springs in the battery compartment should
touch the negative ends of the batteries.
• Read each assembly step carefully before you
begin.
• During assembly, make sure that all parts are
oriented as shown in the drawings.
1
2
35
1
36
4
3
(+)
35
4
6
Holes
46
5
A
B
Battery
Cover
(–)
AA
Batteries
Advertisement
Table of Contents
