Table of Contents
Advertisement
Installation
The floor must be clean and dry, free from floor polish
and other greasy substances, so that the machine
does not slide about. Do not use any grease as
lubrification.
Installation on deep pile carpets and floor
coverings with foam backings is not recommended, as
the stability of the machine is no longer guaranteed. If
the installation must be done on a carpeted floor, the
openings located at the lower part of the back of the
appliance must remain free. These openings ensure
a good ventilation of your appliance. In case of small
format tiles, place a standard rubber mat under the
machine.
With sprung floors, in particular wooden plank floors
with yielding floor boards, screw down a waterproof
wooden base at least 15 mm thick, across at least 2
floor boards. Wherever possible, place the appliance
in the corner of the room - there wooden floors are most
secure and least liable to resonance vibrations.
Never compensate for small unevennesses in the floor
by placing wood, pasteboard or such like.
The front adjustable feet must be blocked after
installation of the appliance by means of the locking
nuts.
Levelling
It is essential that your machine is absolutely level.
Raise or lower the front feet of the machine; tighten the
nuts of the feet with an adjustable wrench.
Also make sure that the machine does not touch the
wall, the furnitures etc. during the functioning.
This in order to avoid vibrations, noise or displace-
ments of the appliance during operation.
Moving of the appliance
To move your washing machine, put it on its wheels by
turning from the right to the left the special lever
situated at the bottom of the machine. Once the ma-
chine placed at the chosen place, bring back the lever
to its initial original position.
- 19 -
Advertisement
Table of Contents
