Mounted Wire Basket Assembly - Huffy Cruiser Bicycles Owner's Manual

Mounted Wire Basket Assembly (if equipped)
1. Attach Support Legs (39) to bot-
tom of Basket (35) using Bracket
(40), Screws (36) [x2], Wash-
ers (37) [x2] and Nuts (38) [x2].
Tighten Securely.
2. Make sure Support Legs (39) set
between Bracket (40) and Basket
(35) (fi g 04b).
3. If installed, remove Axle Nuts (5).
4. Place Support Legs (39) on to
Axle (B) on both sides.
5. Install Axle Nuts (5) hand tight.
6. Place Basket (35) into position
against upper Bracket (A) and at-
tach with Screws (36) [x2], Wash-
ers (37) [x2] and Nuts (38) [x2].
Tighten Securely.
7. Attach Axle Nuts (5) securely.
8. Tighten Axle Nuts (5) to 21 ft-lbs.
35
40
NOTE: Ensure wheel spins freely without contacting fork or fender.
WARNING: Put the wheel in the center of the fork and tighten
both nuts to the recommended torque of 21 ft.-lbs.
WARNING: Failure to obey these steps can allow the front wheel to
loosen while riding. This can cause injury to the rider or to others.
12
36
37
38
39
39
fig 04b
35
40
5
37
38
A
B
fig 04a