Door Reversal; Special Accessories - AEG Electrolux LAVATHERM 59850 User Manual

8
Installation
WARNING!
The plug must be accessible after installing the machine.
Permanent connection
In the case of permanent connection it is necessary that you install a double pole switch
between the appliance and the electricity supply (mains), with a minimum gap of 3 mm
between the switch contacts and of a type suitable for the required load in compliance
with the current electrical regulations.
The switch must not break the yellow and green earth cable at any point.

Door reversal

To make is easier to load or unload the laundry, the door can be reversed. This operation
must only be carried out by a qualified engineer. Please contact your local service centre.
The engineer will carry out the door reversal at your cost.

Special accessories

• Stacking kit
These intermediate installation kits can be used to arrange the dryer and a washing
machine (60 cm wide, front loaded) as a space-saving washer/dryer stack. The washing
machine is at the bottom and the dryer is at the top.
Read carefully the instructions supplied with the kit.
Available from your Service Force Centre or your specialist dealer
• Draining kit
Installation kit for direct draining of the condensed water into a basin, siphon, gully, etc.
The water reservoir then no longer has to be drained, it must however remain in its
intended position in the machine.
Fixed hose has to be on the suitable height from minimum of 50 cm to maximum of 1
m from floor level and cannot be looped. If possible shorten the draining hose.
Read carefully the instructions supplied with the kit.
Available from your Service Force Centre or your specialist dealer
• Pedestal with the drawer
To situate the dryer at the optimal height and have some additional space to store (e.g.
laundry).
Read carefully the instructions supplied with the kit.
Available from your Service Force Centre or your specialist dealer