Technical Specifications - AEG Electrolux LAVATHERM 59850 User Manual

24

Technical specifications

Setting
Water hardness
Emptying water res-
ervoir - warning
off (Only when drain
2)
kit is used)
1) Water contains, a variable quantity of limestone and mineral salts of which quantities vary according to
geographical locations thus varying its conductivity values. Relevant variations of the conductivity of the water
compared to those prefixed by the factory could slightly influence the residual humidity of the laundry at the
end of the cycle. Your dryer allows you to regulate the sensitivity of the drying sensor based on conductivity
values of the water.
2) By default the warning LED is always on at the end of the drying cycle or during the cycle if the water reservoir
is full. When using an external drain for the condensed water warning can be off.
Technical specifications
Height x width x depth
Drum volume
Depth with loading door open
Height can be adjusted by
Weight when empty
Loading volume (depends on programme)
Voltage
Required fuse
Total power
Energy efficiency class
Energy consumption (7 kg of cotton, pre-
drained at 1000 rpm)
Average annual energy consumption
1) 1. Turn the programme selector to any programme.
2. Press simultaneously the DRYNESS and TIME buttons and hold down
for approx. 5 seconds. The current setting is on the display:
–
–
–
3. Press the START PAUSE button sequentially until you set desired level.
4. To memorise setting press simultaneously the DRYNESS and TIME
buttons or turn knob to OFF position
1. Turn the programme selector to any programme.
2. Press simultaneously the SPIN SPEED and TIME buttons and hold
down for approx. 5 seconds.
The current setting is on the display:
– warning
– warning
2)
Implementation
low conductivity <300 μS/cm
medium conductivity 300-600 μS/cm
high conductivity >600 μS/cm
icon and
icon and
85 x 60 x 58 cm
108 l
109 cm
1.5 cm
approx. 56 kg
1) max. 7 kg
230-240 V
13 A
1050 W
A
1.9 kWh
126.2 kWh
- warning message is off
- warning message is switched on