Important Safety Instructions; Save These Instructions - Kenmore 116.22175C Owner's Manual

IMPORTANT SAFETY INSTRUCTIONS

WARNING
Your safety is important to us. To reduce the risk of fire, electrical shock,
injury to persons or damage when using your vacuum cleaner, follow basic
safety precautions including the following:
Read all instructions in this manual before
assembling or using your vacuum cleaner.
Use your vacuum cleaner only as
described in this manual. Use only with
Sears recommended attachments.
Disconnect electrical supply before
servicing or cleaning out brush area.
Failure to do so could result in electrical
shock or brush suddenly starting.
Do not leave vacuum cleaner when
plugged in. Unplug from outlet when not in
use and before servicing.
To reduce the risk of electrical shock – Do
not use outdoors or on wet surfaces.
Do not allow to be used as a toy. Close
attention is necessary when used by or
near children.
Do not use with damaged cord or plug. If
vacuum cleaner is not working as it should,
has been dropped, damaged, left outdoors,
or dropped into water, return it to a Sears
Service Center.
Do not pull or carry by cord, use cord as a
handle, close door on cord, or pull cord
around sharp edges or corners. Do not run
vacuum cleaner over cord. Keep cord away
from heated surfaces.
Do not unplug by pulling on cord. To
unplug, grasp the plug, not the cord.
Do not handle plug or vacuum cleaner with
wet hands.
Do not put any objects into openings.
Do not use with any opening blocked; keep
free of dust, lint, hair and anything that may
reduce airflow.
Keep hair, loose clothing, fingers, and all
parts of body away from openings and
moving parts.
Turn off all controls before unplugging.

SAVE THESE INSTRUCTIONS

Proper assembly and safe use of your vacuum cleaner are your responsibilities.
Your vacuum cleaner is intended for
carefully for important use and safety information. This guide contains safety
statements under warning and caution symbols.
Use extra care when cleaning on stairs. Do
not put on chairs, tables, etc. Keep on
floor.
Do not use vacuum cleaner to pick up
flammable or combustible liquids (gasoline,
cleaning fluids, perfumes, etc.), or use in
areas where they may be present. The
fumes from these substances can create a
fire hazard or explosion.
Do not pick up anything that is burning or
smoking, such as cigarettes, matches, or
hot ashes.
Do not use vacuum cleaner without dust
bag and/or filters in place.
Always change the dust bag after
vacuuming carpet cleaners or freshener,
powders and fine dust. These products clog
the bag, reduce airflow and can cause the
bag to burst. Failure to change bag could
cause permanent damage to the vacuum
cleaner.
Do not use the vacuum cleaner to pick up
sharp hard objects, small toys, pins, paper
clips, etc. They may damage the vacuum
cleaner or dust bag.
Do not operate vacuum cleaner without the
exhaust filter or exhaust filter door in place
(If applicable).
The hose contains electrical wires. Do not
use when damaged, cut, or punctured.
Replace if cut or worn. Do not pick up
sharp objects.
Always turn off and unplug the vacuum
cleaner before connecting or disconnecting
either hose, Handi-Mate Jr.® (if applicable),
or nozzle.
Hold plug when rewinding onto cord reel.
Do not allow plug to whip when rewinding.
You are responsible for making sure that
your vacuum cleaner is not used by anyone
unable to operate it properly.
Household use . Read this Owner's Manual
4
POUR REMETTRE LA
COURROIE EN PLACE
1. Poser la
nouvelle
courroie
pardessus
l'entraînement
Entraînement
du moteur, du moteur
puis pardessus
Entraînement
Capuchon de brosse
l'entraînement
d'extrémité Agitateur
de brosse.
REMARQUE:
Voir PIÈCES ET CARACTÉRISTIQUES pour le
numéro de la courroie.
2. Placer l'ensem-
ble de l'agitateur
dans le Power-
Mate ® .
3. Remettre le
couvercle de l'agi-
tateur en alignant
Languettes
les languettes
avant et les fentes
et tournant vers le
bas jusqu'à ce
que les loquets se
trouvent en place
Couvercle de
avec un déclic. l'agitateur
POUR CHANGER L'AMPOULE
1. Enlever le couvercle du Power-Mate ® comme
démontré dans la section POUR CHANGER LA
COURROIE ET NETTOYER L'AGITATEUR.
2. Pousser sur l'am-
Enfoncer
et tourner
poule en la tournant
vers la gauche, puis
tirer pour l'enlever.
4. Aligner le
devant du
couvercle et la
base. Poser le
couvercle sur le
bord avant de la
base comme
illustré.
Couvercle
Base
5. Tourner le couvercle
arrière. Appuyer
fermement sur le
couvercle jusqu'á ce
que les languettes
arrière se trouvent en
place avec un déclic.
6. Retourner Power-Mate ® sur le dos et remettre les
deux (2) vis du couvercle.
3. Pousser sur l'am-
Enfoncer
poule en la tournant
et tourner
vers la droite pour la
remplacer. L'ampoule
ne doit pas dépasser
130 volts (15 watts).
4. Remettre le couvercle du Power-Mate ® comme
démontré dans la section POUR CHANGER LA
COURROIE ET NETTOYER L'AGITATEUR.
REMARQUE: Voir PIÈCES ET
CARACTÉRISTIQUES pour le numéro de l'ampoule.
17