Parts And Features Exhaust Filter Changing; Assembly Instructions Power-Mate® Care - Kenmore 116.22175C Owner's Manual

EXHAUST FILTER CHANGING
WARNING
Fire and/or Electrical Shock Hazard
Do not operate with a clogged exhaust
filter or without the exhaust filter or
exhaust filter cover installed.
EXHAUST FILTER
HEPA
The exhaust filter cartridge must be
replaced when dirty. Replace the filter when
the entire surface area is covered evenly.
The filter CANNOT be washed as it will
lose its dust trapping ability.
NOTE: See PARTS AND FEATURES for
exhaust filter number.
1. Pull up on
Exhaust
the exhaust fil-
Filter
ter cover to
Cover
remove from
the canister
and lay aside.
POWER-MATE ® CARE
Always follow all safety precautions before
performing maintenance to the Power-
Mate ® .
2. Slightly push
the exhaust filter
Exhaust cartridge to the
Filter
side, as shown in
the illustration, and
pull up to remove.
3. Replace the
exhaust filter car-
tridge, carefully Exhaust
Filter
positioning it so
that the side
shown in the
illustration goes
down under the
ribs. Then push
the other side down until it snaps into place.
Place the new filter into the canister with the
foam seal down.
4. Replace the
exhaust filter
Exhaust
cover by engag-
Filter Cover
ing the two tabs
on the rear and
Tabs
pushing down in
front until it
snaps closed.
WARNING
Electrical Shock Or Personal Injury
Hazard
Disconnect electrical supply before per-
forming maintenance to the vacuum
cleaner. Failure to do so could result in
electrical shock or personal injury from
vacuum cleaner suddenly starting.
16
TUYAU SOUPLE
Interrupteur à trois positions
(OFF/ Floor / Carpet)
Poignée
Réglage
d'aspiration
Pivot de
tuyau
TRAîNEAU
Objet Pièce N o . Pièce N
aux
Etats-Unis Canadá
Sac à poussière 20-50558 20-50403
Filtre d'échappement 20-86880 20-40320
Filtre de sécurité 20-86883 20-40321
du moteur
ACCESSOIRES
Suceur
plat
Brosse à
dépoussiérer
Brosse
à tissu
Brosse à
Handi-Mate Jr.®
plancher
o .
au
5