Husqvarna 532RBS Operator's Manual page 10

5. Set up
2. Attach the lever as shown in the picture and screw it
securely. (SE6)
SE6
ADJUSTING THROTTLE CABLE
• Proper play of the throttle cable is 1–2mm. Place the
throttle lever to the lowest speed position (i.e. fully
released status). Pull the throttle cable lightly with
fingers to check its play. Readjust the position of
cable adjuster if the play is too large or too small. To
readjust, slacken a lock nut. Turn the cable adjuster
clockwise to increase the play, or counterclockwise to
decrease the play. Lock the cable adjuster with the
lock nut after readjustment. (SE7)
SE7
ATTACHING THE HANDLE
NOTE
The loop handle should be located between the arrow
mark and the throttle lever.
• Attach the loop handle as shown in the
accompanying diagram. Note that it is recommended
that you attach the handle so that the handle is
located some 30–40cm away from the front end of
the right-hand grip. (SE8)
10
(1) Throttle lever
(2) Hole
(3) Throttle cable
(4) Screw
(5) Nut
(1) Cable adjuster
(2) Lock nut
(3) Throttle cable
SE8
WARNING
Stop tightening the screws when the gap A
becomes zero.
ATTACHING THE DEBRIS GUARD
WARNING
Never use the machine without the debris guard.
• Attach the guard to the clamp on the outer pipe just
touching the gearcase. Fix it with 2 bolts. (SE9)
SE9
BLADE
WARNING
• Do not install or remove the blade while the
engine is in operation.
• Use HUSQVARNA's genuine replacement blades
and metal fixtures when installing the blade.
• When installing or removing the blade, fix the
machine securely, and wear robust gloves.
• The blade turns counterclockwise (viewed from
the gear case). When using an inside-out blade,
check the direction of the blade before installing
it. In particular, if you install a chip saw in the
wrong direction, the chips might break and
scatter.
1. Loosen the bolt remove holder A and holder B from
the gear case. (SE10)
(1) Loop handle
(2) Screw
(3) Washer
(4) Nut
(5) Throttle lever
(6) Right hand grip
(1) Bolt (M5x25)
(2) Clamp
(3) Debris guard
(4) Place to be
attached for blade
use
(5) Place to be
attached for line
head