Other Features - Kenmore 970.C4808 Series Use & Care Manual

Other Features

Status Display/Status Lights
The estimated total cycle time will be displayed when the
cycle is selected. The time may increase if water pressure is
low, oversudsing occurs or the load becomes unbalanced.
The approximate time remaining will be displayed during
the cycle.
Oversuds Detection
A situation where oversudsing has been detected by the
washer will result in the washer automatically adding up to
4 extra rinses to attempt to clear the suds. Each extra rinse
the washer performs to clear the suds will add 5 minutes to
the cycle display time. If an excessive amount of detergent
has been added and additional rinsing has not corrected
the issue, "
TOO MUCH DETERGENT
Vent Latch
Help prevent odor buildup and mildew between washes by
utilizing your washer's vent latch feature. To apply the vent
latch, (1) open the door slightly, (2) lift the latch arm and
then (3) press the arm down onto the plastic door strike,
snapping it in place.
The vent latch can be released either of two ways - by
pulling door out and manually returning latch arm to lower
position or by pushing door shut and allowing latch arm to
continue its pivot upward.
IMPORTANT
Do not attempt to close door if vent latch arm is
disengaged and arm is in an outward position. Return
latch arm to lower position before closing and latching
the door.
NOTE
The vent latch may become dislodged from hinge point
if door closure is attempted while latch arm is not in
an acceptable closing position. The latch arm can be
snapped back in at the hinge location. Washer will still
operate without latch arm installed.
" will be displayed.
11
Operating Instructions
STATUS DISPLAY
The following will also be displayed at the ap-
propriate times during the cycle:
DOOR LOCK
PREWASHING
WASHING
ADDING STEAM
3
1
RINSING
DRAINING
SPINNING
CYCLE COMPLETE
SNAP
HINGE
2