Nortel 1140E User Manual page 62

Configuring Local Menu options
If the base is powered off, the headset is only paired to the 1140E and
pressing the "telephone" key connects you to the 1140E.
Note: Unless you need to dual pair the GN6210 headset, operating
the headset with the 1140E is simpler if it is only used with its
charging-only base. The desktop telephone base should be powered
off if it is not in use.
Interaction with wired headsets
If you connect a Bluetooth wireless technology headset and a wired
headset to the same IP Phone 1140E, the two interact as follows:
• If no wireless headset is paired, the wired headset works as normal.
Likewise, if a wireless headset is paired with the set, but is not in
range, the wired headset works as normal.
• If the Use BT headset checkbox is selected, the wireless headset is
used as the phone headset.
Note: The Bluetooth wireless technology headset can work only if it is
within range of the phone; as the wireless headset approaches the
edge of its radio range, the audio quality degrades and radio
interference noise increases. When the wireless headset is in
connecting range, the
even if a wired headset is attached. If a wireless headset moves out
of connecting range, a special beep sounds in the headset indicating
the connection was lost. For example, on the GN6210, this is a series
of tones, high to low, the same as the beeps that sound when a call
ends.
When you do not want to use your Bluetooth technology headset
If a Bluetooth wireless technology headset is connected, and you want to
use the wired headset, you can switch between the two. It is not
necessary to unpair or disable the wireless headset.
Note: You can switch between a wired and wireless headset and
back again either when the phone is idle or during an active call.
62
Headset
key controls the wireless headset,