Before you begin
Connecting the components of the phone
WARNING Your IP Phone 1140E is shipped with the
base locked in position. To avoid damaging your phone,
press the wall-mount lever, located just under the
Handsfree key as indicated in Figure 7 on page 31, to
release the base and pull it away from the phone.
1. Remove the stand cover. Pull upward on the center catch as
indicated in Figure 5, and remove the stand cover. The cable routing
tracks are now accessible.
CAUTION
Damage to Equipment
Do not plug your IP Phone 1140E into a regular
telephone jack. This results in severe damage
to the IP Phone. Consult your system
administrator to ensure that you plug your
telephone into a 10/100BaseT Ethernet jack.
CAUTION
Your IP Phone 1140E is designed for use in an
indoor environment only.
Connecting the components
27