HP Elite 7100 Microtower Quickspecs page 7

QuickSpecs
System Details
Weight & Dimensions
Technology and Features Memory Type
RAID
SMART Technology*
(Self-Monitoring, Analysis
and Reporting Technology)
* This feature is inoperable when a RAID configuration is enabled.
Chassis Dimensions
(H x W x D)
Packaged Dimensions
(L x W x H)
System Weight
Shipping Weight
NOTE: For systems configured with more than 3 GB of memory and a 32-bit operating system, all memory
may not be available due to system resource requirements. Addressing memory above 4 GB requires a 64-
bit operating system.
Hard Drive Interfaces
Supported
Redundant Array of Independent Drives
RAID 0,1 are the RAID configurations that HP Elite 7100 Microtower PC products offer as factory
configurations. The pre-configured systems:
Are complete RAID systems and have both drives installed.
Have the necessary Option ROM configuration.
Are pre-loaded and pre-installed with all required Intel software.
Include a preinstalled operating system that is in mirrored mode out of the box.
Allows hard drives to monitor their own health and to raise flags if imminent failures were predicted
Predicts failures before they occur. Tracks fault prediction and failure indication parameters such as
re-allocated sector count, spin retry count, calibration retry count
By avoiding actual hard drive failures, SMART hard drives act as "insurance" against unplanned user
downtime and potential data loss from hard drive failure
IOEDC: I/O Error Detection Circuitry
Detects errors in Read/Write buffers on HDD cache RAM
Interface in F10 setup provides confirmation of SMART support.
DA - 13571 North America — Version 3 — June 8, 2010
15.14 x 7.27 x 16.36 in
385 x 185 x 416 mm
19.13 x 21.875 x 10.13 in
490 x 556 x 257 mm
22.4 lb (10.2 kg)
30.8 lb (14.0 kg)
PC3-10600 DDR3 (1333 MHz) non-ECC
Up to 16 GB system memory standard
Serial ATA
HP Elite 7100 Microtower PC
Page 7