Brushing Instructions - Philips Sonicare Quick Manual

The battery charge indicator in the power on/off button flashes to
,
indicate that the toothbrush is charging.
When the Sonicare is fully charged, the battery charge
,
indicator stops flashing and remains on.
Note: If the battery charge of the Sonicare is low, you hear 3 beeps and the
battery charge indicator flashes rapidly for 30 seconds after the brushing cycle.
Note: To keep the battery fully charged at all times, you may keep the
Sonicare on the charger when not in use. When the battery is fully charged,
the charger uses a minimal amount of energy. It takes at least 24 hours to
fully charge the battery.
Using the Sonicare For Kids

Brushing instructions

For children under age 8, it is recommended that a parent or adult
caregiver perform toothbrushing.
1 Wet the bristles and apply a small amount of toothpaste.
2 Place the toothbrush bristles against the teeth at a slight angle
towards the gumline (Fig. 6).
3 Press the power on/off button to switch on the Sonicare.
4 Apply light pressure to maximise Sonicare's effectiveness and let
the Sonicare toothbrush do the brushing for you.
5 Gently move the brush head slowly across the teeth in a small back
and forth motion so the longer bristles reach between the teeth.
Continue this motion throughout the brushing cycle.
Note: To make sure you brush evenly throughout the mouth, divide the mouth
into 4 sections using the KidPacer feature (see chapter 'Features').
6 Begin brushing in section 1 (outside top teeth) until a tune indicates it is
time to move to section 2 (inside top teeth). At the next tune, move to
section 3 (outside bottom teeth). The next tune indicates it is time to
move to section 4 (inside bottom teeth). The toothbrush automatically
switches off at end of the brushing cycle (Fig. 7).
ENGLISH
9