IBM 10/100 Ethernet Mini-PCI Adapter User Manual page 22

22. When you are prompted to restart the computer, click Yes.
23. If you had Service Pack 3 or later installed prior to setting up the network adapter,
reinstall it after Windows NT has completed the computer restart.
Installing the device driver for Windows NT 4.0 with networking installed
To install the 3Com 10/100 Mini-PCI Ethernet Adapter device driver in Windows NT 4.0
with networking installed:
1. Insert the IBM 10/100 Ethernet Mini-PCI Adapter with 56K Modem by 3Com CD
that comes with your notebook computer into the CD-ROM drive.
2. Find and open the LANSETUP folder that is on the CD.
3. Double-click the SETUP.EXE file.
4. Follow the on-screen instructions.
5. In the Control Panel, double-click Network.
6. Click the Adapter tab, and then click Add.
7. Click Have Disk. Type C:\WINNT\OPTIONS\CABS, and then click OK.
8. Select 3Com 10/100 Mini PCI Ethernet Adapter, and then click OK.
9. In the 3Com network adapter window, accept the default settings and click Continue.
Values are automatically assigned.
10. After Windows copies the required files, it displays the network adapter name, 3Com
10/100 Mini PCI Ethernet Adapter. Click Close. Depending on your current
network settings, the Microsoft TCP/IP Properties window might open.
11. When you are prompted to restart the computer, click Yes.
12. If you had Service Pack 3 or later installed prior to setting up the network adapter,
reinstall it after Windows NT has completed the computer restart.
Uninstalling the device driver for Windows NT 4.0
Sometimes previous or incomplete installations leave problems that can affect the
operation of the network adapter. Possible problems might be indicated if the 3Com
10/100 Mini PCI Ethernet Adapter is not working.
If the device driver installation is unsuccessful for any reason, try removing the software
and repeating the device driver installation procedures. If you followed the steps in the
Windows NT 4.0 device driver installation section, the existing device driver was
uninstalled prior to the installation. However, you can also use the following steps to
uninstall a device driver:
1. Click Start
2. Double-click the Network icon.
3. Click the Adapters tab.
4. Select 3Com 10/100 Mini PCI Ethernet Adapter, and then click Remove.
5. Click OK, and then restart the computer and reinstall the device driver.
Note: If you remove all of the networking components after performing the
preceding procedure, be sure to reinstall the device driver using the procedure
listed in "Installing the device driver for Windows NT 4.0 with no networking
installed" on page 2-13. If you do not remove all of the networking
components, reinstall the device driver using instructions given in "Installing
the device driver for Windows NT 4.0 with networking installed" on page
2-14
IBM 10/100 Ethernet Mini-PCI Adapter with 56K Modem by 3Com User's Guide
Settings Control Panel.