IBM 10/100 Ethernet Mini-PCI Adapter User Manual page 35

1. Insert the IBM 10/100 Ethernet Mini-PCI Adapter with 56K Modem by 3Com CD
that comes with your notebook into the CD-ROM drive.
2. Find and open the MDMSETUP folder that is on the CD.
3. Double-click the SETUP.EXE file.
4. Follow the on-screen instructions. When you are prompted to do so, restart the
computer.
5. After the computer restarts and the Insert Disk message displays, click OK.
6. In the Copy files from box, type C:\WINDOWS\OPTIONS\CABS, and then click OK.
7. Your computer will go through a brief installation process. When the installation
completes, your modem will be reinstalled.
Uninstalling the device driver in Windows 95 and Windows 98
Sometimes previous or incomplete installations leave problems that can affect the
operation of the network adapter. If the device driver installation is unsuccessful for any
reason, try removing the software and repeating the device driver installation procedures.
Any changes to the system files made between the installation and the uninstallation will
be lost because the files that existed before the installation will be restored.
If you followed the installation procedure steps in the "Installing the device driver for
Windows 95 and Windows 98" section, the existing device driver was uninstalled prior to
the installation. However, you can also use the following steps to uninstall a device driver:
1. Click Start
2. Double-click Add/Remove Programs.
3. Select the 3Com 56K V.90 Mini PCI Modem.
4. Click Add/Remove.
When the uninstallation completes, restart your computer.
Windows NT 4.0 device drivers
This section contains information on installing and uninstalling the device driver for
Windows NT 4.0.
Installing the device driver in Windows NT 4.0
The modem device driver is already installed. This section contains the installation
procedure if you need to reinstall the device driver after a catastrophic failure.
1. Insert the IBM 10/100 Ethernet Mini-PCI Adapter with 56K Modem by 3Com CD
that comes with your notebook computer into the CD-ROM drive.
2. Find and open the MDMSETUP folder that is on the CD.
3. Double-click the SETUP.EXE file.
4. Follow the on-screen instructions.
5. In the Modem Setup window, select Install.
6. Click OK.
Uninstalling the device driver in Windows NT 4.0
Sometimes previous or incomplete installations leave problems that can affect the
operation of the network adapter. If the device driver installation is unsuccessful for any
reason, try removing the software and repeating the device driver installation procedures.
Settings Control Panel.
3. Connecting and using the 3Com V.90 Mini-PCI modem
3-9