IBM 10/100 Ethernet Mini-PCI Adapter User Manual page 21

networking installed" on page 2-13. If networking has already been installed on your
computer, go to "Installing the device driver for Windows NT 4.0 with networking
installed" on page 2-14.
Installing the device driver for Windows NT 4.0 with no networking installed
To install the 3Com 10/100 Mini-PCI Ethernet adapter device driver in Windows NT 4.0
with no networking installed:
1. Insert the IBM 10/100 Ethernet Mini-PCI Adapter with 56K Modem by 3Com CD
that comes with your notebook computer into the CD-ROM drive.
2. Find and open the LANSETUP folder that is on the CD.
3. Double-click the SETUP.EXE file.
4. Follow the on-screen instructions.
5. Double-click Network in the Control Panel.
6. When the Windows NT Networking is not installed. Do you want to
install it now? prompt displays, click Yes to open the Network Setup Wizard
window.
7. Place a check in the Wired to the network check box, and then click Next.
8. When you are prompted to search for a network adapter, click Select from List.
9. Click Have Disk. Insert the Windows NT installation diskette into the diskette drive,
and then click OK.
10. Select 3Com 10/100 Mini PCI Ethernet Adapter, and then click OK. The Network
Adapters list displays a check mark next to the 3Com network adapter.
11. Click Next to continue.
12. In the Network Protocols list, place a check mark next to each network protocol
required for your site, and then click Next.
13. In the Network Services window, there are four default options. Unless you are
following specific guidelines from your MIS department, select the default settings.
14. Click Next to install the selected components.
15. When you are prompted to do so, type the name of the directory that contains the
Windows NT installation files (C:\WINNT\OPTIONS\CABS), and then click Continue.
16. When the computer prompts you again for the Windows NT installation files, click
Continue.
17. In the 3Com Network Adapter window, accept the default settings, and then click
Continue. Values are automatically assigned.
18. When the window for enabling or disabling protocols opens, click Next.
19. When Windows NT is ready to start the network, click Next to copy the network
files.
20. When you are prompted to do so, provide your computer name and workgroup or
domain name.
21. When the system displays the Networking has been installed on your
computer message, click Finish.
2. Connecting and using the 3Com 10/100 Mini-PCI Ethernet adapter
2-13