Changing The Usb Receiver Channels; Installing The Software - IBM Wireless Keyboard and Mouse User Manual

Changing the USB receiver channels

To confirm and change the channels on your USB dual receiver, do the
following:
1. Make sure the USB connector 1 is properly inserted into your computer.
2. Press one of the blue buttons, 2 or 3 , on the bottom of the Dual
Wireless Receiver.
3. Note that the device icon LED will be on.
4. Press the blue button on the bottom of the Dual Wireless Receiver that
corresponds to the device icon (shown above as mouse 2 , keyboard 3 ).
5. The LED flashes off.
6. Press the Windows key on your keyboard or move the mouse to confirm
functionality.
7. Repeat the above steps for the other device.

Installing the software

To install the software, do the following:
1. Click Start.
2. Select Run.
3. Type x:\setup, where x is the letter of your CD-ROM drive.
4. The keyboard setup program begins. You will be prompted for selections.
5. Click Next.
6. Click Next.
7. Click Finish.
8. The mouse setup program begins. You will be prompted for selections.
9. Click Next.
1-4
IBM Wireless Keyboard and Mouse: User's Guide