Installing And Connecting The Internal Computer - Smart Technologies SMART Board 3000i Installation Manual

Installing and Connecting the Internal Computer

To position and secure the computer
1 Slide the computer into place above the computer straps, and then use them to secure
it.
NOTE: The straps allow you to roll the cabinet from room to room without removing the
computer. However, these straps will not secure the computer in place during cabinet
transportation. If you move the cabinet, remove the computer first.
2 Locate the tie-wrapped bundle of labeled cables dangling inside the cabinet. In addition
to this cable bundle, AC power, keyboard and mouse cables are located nearby.
To make all cable connections to the computer
1 Connect the Computer 1 Video
2 Connect the Computer 1 Audio
3 Connect the Computer 1 Serial
NOTE: If you're connecting a computer without a serial port, use the SMART USB
adapter (order number USB-ADP) to connect to the Computer 1 Serial cable.
4 Connect the Printer
5 Connect the Network
6 Connect the Mouse
by a mouse symbol) and the PS/2 keyboard port (identified by a keyboard symbol).
7 Connect the AC
12
Network
Computer 1
Video
Computer 1
Audio
Computer 1
Serial
A
Printer
3000i Computer Cables
A
cable to the 25-pin parallel port (printer) connector.
cable to the network card (if applicable).
and Keyboard
power cord to the Computer Power IN port.
3000i Installation Guide
cable to the Monitor Video connector.
cable to the Audio Line OUT.
cable to an available COM port.
cables to the PS/2 mouse port (identified
Mouse
Keyboard