1. Manuals
  2. Brands
  3. Smart Technologies Manuals
  4. Whiteboard
  5. SMART Board 3000i
  6. Setup

Smart Technologies 3000i Setup

Rear projection interactive whiteboard
Hide thumbs Also See for 3000i:
1
2
3
4
5
6

Advertisement

Table of Contents

Rear Projection SMART Board
Whiteboard Setup
WARNING: Two people are required to perform the following procedures.
1. Cut the shipping bands and remove the cardboard covering and plastic wrap from around the
cabinet.
2. Remove the band that holds the pallet ramp against the touch screen. Lower the pallet ramp.
Pallet Ramp
Cut this band
Touch Screen
Rear Projection SMART Board 3000i Interactive Whiteboard Setup
™
3000i Interactive
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 3000i and is the answer not in the manual?

Questions and answers

Related Manuals for Smart Technologies 3000i

Summary of Contents for Smart Technologies 3000i

  • Page 1 1. Cut the shipping bands and remove the cardboard covering and plastic wrap from around the cabinet. 2. Remove the band that holds the pallet ramp against the touch screen. Lower the pallet ramp. Pallet Ramp Cut this band Touch Screen Rear Projection SMART Board 3000i Interactive Whiteboard Setup...
  • Page 2 Cardboard Cover Foam-Lined Cardboard Angle Bracket × 4 5. Using a Phillips® No. 2 screwdriver, loosen the four captive corner screws that secure the cabinet top to the angle brackets. Captive Fasteners Rear Projection SMART Board 3000i Interactive Whiteboard Setup...
  • Page 3 You can also remove the four angle brackets from the pallet, if necessary. You can now wheel the lower cabinet down the pallet ramp. Angle Brackets × 4 Orange Shipping Brackets × 4 Rear Projection SMART Board 3000i Interactive Whiteboard Setup...
  • Page 4 10. Using the hex key provided in the accessory kit, insert and tighten two of the four supplied security screws to the underside of the top cabinet, on either side of the pen tray. Hex Key Rear Projection SMART Board 3000i Interactive Whiteboard Setup...
  • Page 5 Do not apply isopropyl alcohol, water or acetone to the rear surface of the touch screen. Any of these fluids will damage the diffusion coating, resulting in a permanent deterioration in display quality. Rear Projection SMART Board 3000i Interactive Whiteboard Setup...
  • Page 6 99-261-00 REV D0 © 2001–2006 SMART Technologies Inc. All rights reserved. The SMART logo is a trademark of SMART Technologies Inc. All other third-party product and company names may be trademarks of their respective owners. Contents are subject to change without notice. 02/2006.

Table of Contents