Appendix B: Connecting Rack-Mount Equipment To The Projector Platform - Smart Technologies SMART Board 4000i Installation Manual

Appendix B: Connecting Rack-Mount Equipment to the
Projector Platform
Use the clip-on nuts (included) to secure rack-mount equipment to the sides of the projector
platform, just below the projector itself. The projector platform can accommodate rack-mount
equipment with a width of 19" (48.3 cm).
To connect rack-mount equipment to the projector platform
1. Attach the clip-on nuts from the accessory kit to the sides of the projector platform.
2. Connect the rack-mount equipment to the clip-on nuts using 10-32 × 1/2" fasteners (not
included).
99-00582-20 REV A0
19" Rack-mount
Equipment

Appendix B: Connecting Rack-Mount Equipment to the Projector Platform

Clip-on Nuts
33