Timer; Control Panel And Oven Door Lock; Oven Temperature Control - Maytag GAS RANGE Use & Care Manual

To Cancel the Clock Display:
If you do not want the time of day to display:
Press and hold CANCEL and CLOCK for 3 seconds. The time of
day will disappear from the display.
When the clock display is canceled, press CLOCK to briefly
display the time of day.
To Restore the Clock Display:
Press and hold CANCEL and CLOCK for 3 seconds. The time of
day will reappear in the display.
The Timer can be set in hours or minutes up to 99 hours and
59 minutes and counts down the set time.
The Timer can be used independently of any other oven function.
It can also be set while another oven function is operating.
NOTE: The Timer does not start or stop the oven.
To Set:
1. Press TIMER.
"0:00" and "TIMER" will flash in the display.
2. Use the number keypads to set the length of time. The
selected time appears in the display and "TIMER" continues
to flash.
3. Press TIMER again or wait 4 seconds. Time will begin
counting down, and "TIMER" is displayed.
When the set time ends, 1 long beep will sound. and "TIMER"
and "End" will be displayed
4. Press TIMER to clear the display.
To Cancel:
1. Press TIMER and set time to "0:00."

Control Panel and Oven Door Lock

The lock feature shuts down the control panel pads (buttons) and
locks the oven door to prevent unintended use of the oven(s).
The lock feature is preset unlocked, but can be locked.
If the oven is currently in use, the controls cannot be locked.
To Lock Control Panel and Oven Door:
Press and hold CANCEL and COOK & HOLD for 3 seconds
(Press the CANCEL pad first.) "OFF" appears in the display and
"LOCK" flashes while the door is locking. Once the oven door is
locked "LOCK" is displayed.
To Unlock Control Panel and Oven Door:
Press and hold CANCEL and COOK & HOLD for 3 seconds
(Press the CANCEL pad first.) "OFF" disappears in the display
and "LOCK" flashes while the door is unlocking. Once the oven
door is unlocked "LOCK" disappears from the display.
8

Timer

Oven Temperature Control

IMPORTANT: Do not use a thermometer to measure oven
temperature because opening the oven door and element or
burner cycling may give incorrect readings.
The oven provides accurate temperatures; however, it may cook
faster or slower than your previous oven, so the temperature
calibration can be adjusted. It can be changed in Fahrenheit or
Celsius.
A minus sign means the oven will be cooler by the displayed
amount. The absence of a minus sign means the oven will be
warmer by the displayed amount. Use the following chart as a
guide.
ADJUSTMENT °F
(ADJUSTMENT °C)
5° to 10°F (3° to 6°C)
15° to 20°F (9° to 12°C)
25° to 35°F (15° to 21°C)
-5° to -10°F (-3° to -6°C)
-15° to -20°F (-9° to -12°C)
-25°F (-15°C)
To Adjust Oven Temperature Calibration:
1. Press BAKE.
2. Enter 550° using the number keypads.
3. Immediately press and hold BAKE pad for several seconds or
until "0°" appears in the display.
If the oven temperature was previously adjusted, the change
will be displayed. For example, if the oven temperature was
reduced by 15 degrees, the display will show -15°.
4. Press AUTOSET to adjust the temperature. Each time
Autoset is pressed, the temperature will increase by 5°F
(3°C). The adjustment can be set between 35°F (21°C) and
-35°F (-21°C).
Pressing Autoset will cycle through increasing the oven
temperature to 35°F (21°C). Continuing to press Autoset will
cycle through decreasing the oven temperature (from
-5°F [-3°C] to -35°F [-21°C]).
5. The time of day will automatically reappear in the display.
You do not need to readjust the oven temperature if there is a
power failure or interruption. Temperature adjustments can be
made to Bake, Convect Bake (on some models) and Convect
Roast (on some models) only. Broil, Warm and Self-Clean
temperatures cannot be adjusted.
To Display Temperatures in °C instead of °F:
1. Press and hold the CANCEL and BAKE buttons for
3 seconds. A single beep will sound, and the current setting
will be displayed (°F or °C).
If no change is made, the range will return to the existing
setting after 30 seconds.
2. To change the setting, press AUTOSET. Press AUTOSET
again to return to the previous setting. Wait 5 seconds, and
the setting change will be complete.
COOKS FOOD
...a little more
...moderately more
...much more
...a little less
...moderately less
...much less