Master Declaration; When The Master Breaks Down - Master Declaration At The Back-Up Master - Sharp UP-3500 Instruction Manual

2. Master declaration

When the master or back-up master breaks down, the master declaration procedure should be taken to
inform satellites of the breakdown.
(1) When the master breaks down – Master declaration at the back-up master
Flow of a master declaration at the back-up master
Master
1) Detection of a breakdown
1) A satellite detects a breakdown of the master through the system retry function when sending
updated GLU data (and clerk data*) to the master. At this point, the message "MASTER DOWN"
appears in the pop-up window of the display of the satellite.
(For the system retry function, see pages 55–56.)
2) The master declaration operation must be done at the back-up master. This operation informs all
the satellites that the master has broken down and the back-up master will serve as the master
hereafter. (During this process, any other operation cannot be done at each satellite.)
3) Each satellite in the IRC system starts sending updated GLU data (and clerk data*) only to the
back-up master.
4) The back-up master receives the data and sends back an acknowledgment signal to the satellites.
*Only for the centralized clerk file system
The master declaration procedure is as follows:
1.
Enter the PGM2 mode from the mode selection window.
2.
Select "7 DECLARE & RECOVERY MA/BMA" from the displayed menu.
The DECLARE & RECOVERY MA/BMA window will appear.
3.
Select "1 DECLARE MASTER&STOP DB UPDATE."
While the master is down, the back-up master performs T-LOG polling as well.
NOTE
50
(Transmission stops.)
2) Master
declaration
operation
Satellite
3) Updated data
4) Acknowledgment signal
Master declaration
Back-up master