Ip Connectivity Not Complete - Cisco DPC2203C Installation And Operation Manual

IP Connectivity Not Complete

Description
After completing the ranging stage, the cable modem then tries to establish IP
connectivity. In this process the cable modem obtains network connection
information and a cable modem IP address from provisioning servers located on the
network side of the CMTS interface. The cable modem accomplishes this with a
protocol called Dynamic Host Configuration Protocol (DHCP). If the cable modem
fails the establish IP connectivity stage it returns back to the scan for downstream
channel stage.
Note: For more information on this process, see Establish IP Connectivity (on page
10).
The following table illustrates the status of the front-panel LED status indicators
when the IP connectivity not complete condition exists.
LED
1
2
3
4
5
6
7
8
72-4017315-01 Rev B
Label
POWER
DS
US
ONLINE
LINK
TEL 1
TEL 2
BATTERY
Status
ON
ON
ON
OFF
ON or BLINKING
OFF
OFF
ON WHEN BATTERY IS CHARGED

BLINKING WHEN BATTERY CHARGE IS LOW

OFF WHEN BATTERY NEEDS TO BE REPLACED (IF

OBSERVED WITH AC POWER APPLIED TO THE MODEM)

IP Connectivity Not Complete

47