Quick Start; Recommended Use - NEC MultiSync LCD1860NX User Manual

Quick Start

To attach the MultiSync LCD monitor to your system, follow these instructions:
1. Turn off the power to your computer.
2. For the PC or MAC with DVI digital output: Connect the DVI signal cable to the connector of the display card in your
system (Figure A.1). Tighten all screws.
For the PC with Analog output: Connect the 15-pin mini D-SUB to 15-pin mini D-SUB signal cable to the connector of
the display card in your system (Figure A.1).
For the MAC: Connect the MultiSync Macintosh cable adapter to the computer, then attach the 15-pin mini D-SUB signal
cable to the MultiSync Macintosh cable adapter (Figure B.1).
NOTE: Some Macintosh systems do not require a Macintosh cable adapter.
3. For the PC or MAC with DVI digital output: Connect the DVI signal cable to the connector on the back of the monitor.
Place the video signal cable (Figure C.1). Connect only DVI to input 2.
For the PC with Analog output: Connect the 15-pin mini D-SUB to the connector on the back of the monitor. Place the
video signal cable (Figure C.1). Connect only 15-pin mini D-SUB to input 1.
NOTE: Incorrect cable connections may result in irregular operation, damage display quality/components of LCD module
and/or shorten the module's life.
Collect cables and keep them at backside of the stand (Figure C.1). And cover the cables by the optional Cable
management Cover (Figure C.2).
Please check Tilt, Rise and Lower monitor screen when you manage cables.
4. Connect one end of the power cord to the AC inlet on the back of the monitor and the other end to the power outlet
(Figure C.1).
NOTE: Use the supplied AC power cord. If it does not match the shape and the voltage of AC power outlet being used,
please refer to the Recommended Use section for proper use of the AC power cord.
5. The Vacation Switch on the left side of the monitor must be turned on. Turn on the monitor with the front power button
(Figure D.1) and the computer.
NOTE: There are two switches - one on the left side and on the front side of the monitor. DO NOT switch on/off quickly.
6. To complete the setup of your MultiSync LCD monitor, use the following OSM controls:
• Auto Adjust Contrast (Analog input only)
• Auto Adjust (Analog input only)
Refer to the Controls section of this User's Manual for a full description of these OSM controls.
NOTE: If you have any problems, please refer to the Troubleshooting section of this User's Manual.
NOTE: Refer to User's Manual in the NEC LCD Setup Software CD case for installation and operation of this software.
01_English
Figure A.1
3
Macintosh
Cable Adapter
(not included)
English-3
22/08/2002, 9:40
Figure B.1