Hardware: Usage
Wireless Mic – 2.4GHZ
If your department opted for our new 2.4GHZ wireless microphone
system, congratulations. This is an incredible wireless microphone with
excellent range and clarity. The operation is easy and straight forward.
• Inserting the transmitter into the cradle will synch the frequency and
channel between the transmitter and receiver.
• When the 'green' LED light is solid, the battery is charged.
The mic switch needs to be set to "off" to charge the transmitter.
Syncing Transmitter and Cradle
1
Slide the small switch on the bottom of the transmitter to the 'ON'
position.
2
Insert the transmitter into the cradle to allow the units to synch.
3
When the transmitter is ready for use, the 'Talk' light will flash briefly.
Transmitting Audio
Pressing the red 'Talk' button switches the unit between stand-by and
actively transmitting.
If your receiver was installed with the transmit sensor connected
to the DVR, then activating the transmitter with the 'talk' button
will also activate the recorder to begin recording.
Pressing the button again will put the transmitter in stand-by and turn
the recorder off. The exception to this would be if the recorder was already
activated by your emergency equipment. In this case, the recorder would
continue to record but your mic transmitter would be in stand-by and not
transmitting audio to the recorder.
46