Configure Network Authentication Screen - Toshiba Pockey PC e800 User Manual

Configure Network Authentication Screen

A wireless network can be added either when the network is detected or
manually by entering settings information. To determine if authentication
Information is needed, see your network administrator.
Select to enable 802.1x authentication. Default is Enable.
■
Data encryption (WEP Enabled)
Tap here to enable data encryption.
■
The Key is provided for me automatically:
Select if you can obtain WEP key automatically from AP. Almost case
this function is used with 802.1X function. Default is Enable.
■
Network Key (WEP key):
Enter the ASCII characters and symbols that correspond to the mode
selected.
■
■
■
User's Manual
Select EAP type. Default is TLS (EAP-TLS).
64 bits (ASCII)
5-digit ASCII characters or symbols can be entered in Network Key.
128 bits (ASCII)
13-digit ASCII characters or symbols can be entered in Network
Key.
64 bits (HEX)
Hexadecimal 10-digit English letters and numerals can be entered
in Network Key. Letters and numerals that can be entered are 0-9
and A(a) - F(f).
Select to set WEP (Wired Equivalent
Privacy). Default is Disable.
Select to enable shared authentication
(Shared mode). Default is Disable.
Select if you can obtain WEP key
automatically from Access Point. In most
cases, default is Enable.
In "Key", enter the ASCII characters and
symbols corresponding to the selected
WEP.
Select Key as transmit 1 - 4.
Select to show the Properties when you connect to
Access Point with 802.1x authentication.
Wi-Fi Wireless LAN
8-8