Table of Contents
Advertisement
User's Manual
3.4 Making AV Routings or "Ties" Using IR
Remote
The remote control is very simple; outputs are labeled as A-D and
they correspond to 1-4 on the rear of the box. Press the input
channel you want the output connected too.
Note that the IR remote makes connections as soon as you hit
the button!
Figure 8 - IR
It takes about 1 to 2 seconds for the matrix to do the routing
(HDCP handshake requires a little time), so if you are going to
change more than one output, pause for moment between pressing the buttons!
3.5 Saving Presets (routing patterns)
The number of presets accessible from the front panel is the same as the total # of
input and output buttons. Therefore, each front panel button can memorize a pattern.
For a 4x4 matrix, you can recall 8 presets and for a 4x2 you can recall 6 presets.
However, through the IP or Serial port, the unit can store and recall 8 presets
regardless of matrix configuration.
Current tie configurations can be saved as presets (1 through 8) for later recall.
To save the current AV routing pattern, press and hold the PRE button for 3 sec, the
backlit LED will start flashing (this means that save function is activated). Press the
desired input button to save the preset then press the SET button to complete the
operation.
3.6 Recalling Presets (routing patterns)
Press and release the PRE (preset) button. The button will light up solid. Then press
and release one of the channel buttons and hit SET.
10
Advertisement
Table of Contents
