Table of Contents
Advertisement
1.3.2 SPEED SENSOR
To install the speed sensor and spoke magnet, you need cutters and a small screwdriver.
1.
In case, the cycling computer is attached to the stem or if
you are exercising in surroundings with electromagnetic
interference, the distance should be minimized (minimum
30 cm/1'). The speed sensor and cycling computer should
form approximately a 90° angle.
Should the distance between the cycling computer and the
speed sensor be longer than recommended (for example
on mountain bikes due to the front suspension), the speed
sensor could be attached on the same side of the front fork
as the cycling computer. In this case the maximum distance
is 50 cm/1´6".
1. Attach the speed sensor
to the opposite side of the
front fork from the mounted
cycling computer.
The speed sensor and the
cycling computer should be
no more than 30-40 cm/
1'-1'3'' apart.
2. Attach the rubber part to the
2.
3. Pass the cable ties through
3.
4. Adjust the sensor to the front
4.
sensor.
the speed sensor and rubber
part holes.
fork so that the POLAR logo
faces outwards. Adjust the
ties loosely. Do not tighten
them fully yet.
ENGLISH
–
13
Advertisement
Table of Contents
