Saving The Configuration Changes; Rebooting The Phone Remotely - Grandstream Networks GXP21 Series User Manual

Use # as Dial Key
G723 Rate
G726-32 Packing Mode
iLBC Frame Size
iLBC Payload Type
eventlist BLF URI
Special Feature
S C
AVING THE ONFIGURATION
After the user makes a change to the configuration, press the "Update" button in the Configuration Menu.
The web browser will then display a message window to confirm saved changes.
We recommend rebooting or powering cycle the IP phone after saving changes.
R P
EBOOTING THE HONE
Press the "Reboot" button at the bottom of the configuration menu to reboot the phone remotely. The web
browser will then display a message window to confirm that reboot is underway. Wait 30 seconds to log in
again.
Grandstream Networks, Inc.
www.InternetVoipPhone.co.uk | sales@internetvoipphone.co.uk | 0800 088 4846
This parameter allows users to configure the "#" key as the "Send" (or "Dial") key. If
set to "Yes", the "#" key will immediately send the call. In this case, this key is
essentially equivalent to the "(Re)Dial" key. If set to "No", the "#" key is included as
part of the dial string.
Encoding rate for G723 codec. By default, 6.3kbps rate is set.
Select "ITU" or "IETF" for G726-32 packing mode.
iLBC packet frame size. Default is 20ms. For Asterisk PBX, 30ms might be
required.
Payload type for iLBC. Default value is 97. The valid range is between 96 and 127.
If the server supports this feature, user needs to configure an "eventlist BLF" URI on
the service side (i.e.: BLF1006@myserver.com)
On the GXP21xx, under Account page, fill in the ""eventlist BLF" field with the URI
without the domain. (i.e.: BLF1006). Under Basic Settings, please select "eventlist
BLF" in the Multi Purpose Key then choose account number, enter username and
user id.
Default is Standard. Choose the selection to meet special requirements from Soft
Switch vendors.
C
HANGES
R
EMOTELY
GXP21xx User Manual
Firmware version: 1.0.1.66
Page 38 of 41
Last Updated: 05/2011