Grandstream Networks GXP21 Series User Manual page 26

802.1x Mode
Line Keys x
Multi Purpose Key X
Time Zone
Self-Defined Time
Zone
Grandstream Networks, Inc.
www.InternetVoipPhone.co.uk | sales@internetvoipphone.co.uk | 0800 088 4846
This option allows the user to enable/disable 802.1x mode on the phone. The default
value is disabled. To enable 802.1x mode, this field should be set to EAP-MD5.
Once enabled, the user would be required to enter the following information below to
be authenticated on the network:
•
Identity
•
MD5 Password
This allows the user to configure the account mapped to each line key, as well as
enabling SCA (Shared Call Appearance) for the line.
Options available for Key Mode are :
1. Line
2. Shared Line
These options are used to assign a function to the corresponding multi purpose key.
Options available are:
1. Speed Dial.
2. BLF (Busy Lamp Field). This option has to be supported on the PBX and it
indicates the status of the extension. The three possible states are idle
(green), busy (red), ringing (blinking red).
3. Presence Watcher. This option has to be supported by a presence server
and it is tied to the "Do not disturb" status of the phone.
4. Eventlist BLF. This option is similar to the BLF option but in this case the PBX
collects the information from the phones and sends it out in one single notify
message. PBX has to support this feature.
Each function is connected to one of the accounts and has a target username and
user ID.
This parameter controls the date/time display according to the specified time zone.
If "Allow DHCP Option 2 to override Time Zone setting" is checked, the time zone will
be overridden by the DHCP server.
This parameter allows the users to define their own time zone.
The syntax is: std offset dst [offset], start [/time], end [/time]
Default is set to: MTZ+6MDT+5,M3.2.0,M11.1.0
MTZ+6MDT+5,
This indicates a time zone with 6 hours offset with 1 hour ahead which is U.S central
time. If it is positive (+) if the local time zone is west of the Prime Meridian (A.K.A:
International or Greenwich Meridian) and negative (-) if it is east.
M3.2.0,M11.1.0
The 1st number indicates Month: 1,2,3.., 12 (for Jan, Feb, .., Dec)
The 2nd number indicates the nth iteration of the weekday: (1st Sunday, 3
Tuesday...)
The 3rd number indicates weekday: 0,1,2,..,6( for Sun, Mon, Tues,..,Sat)
Therefore, this example is the DST which starts from the second Sunday of March to
the 1st Sunday of November.
GXP21xx User Manual
Firmware version: 1.0.1.66
rd
Page 25 of 41
Last Updated: 05/2011