Upgrading The Wireless Access Point Software - NETGEAR ProSafe WNDAP350 Reference Manual

ProSafe Dual Band Wireless N Access Point WNDAP350 Reference Manual

Upgrading the Wireless Access Point Software

The software of the WNDAP350 wirelss access point is stored in FLASH memory, and can be
upgraded as new software is released by NETGEAR. Upgrade files can be downloaded from
Netgear's Web site. The upgrade file can be sent to the wireless access point using your browser.
Note: The Web browser used to upload new firmware into the WNDAP350 must support
HTTP uploads, such as Microsoft Internet Explorer 6.0 or above or Mozilla 1.5 or
above.
You cannot perform the software upgrade from a computer that is connected to the WNDAP350
wirelss access point with a wireless link. You must use a computer that is connected to the
WNDAP350 wirelss access point with a Ethernet cable.
Warning: When uploading software to the WNDAP350 wirelss access point, it is
important not to interrupt the Web browser by closing the window, clicking a
link, or loading a new page. If the browser is interrupted, the upload may fail,
corrupt the software, and render the WNDAP350 completely inoperable.
Management
v2.0, April 2013
3-5