Zanussi ZB 350 Instruction Booklet page 15

Failure to align the top edge of the decor
panel with the template will prevent the
visor from opening when installed.
3. Before drilling, use a tape measure to
check the distances of the screw holes
(as given on the template). The template
may have altered due to dampness after
manufacture.
4. Use the 6 x 15mm (
screws provided to attach the decor
panel to the hood visor.
To Refit the Hood with Decor Panel
K
Attached
1. Insert the upper visor guides into the
upper track in the front of the casing.
2. Hinge down the bottom edge of the visor
and insert the lower guides into the track
in the bottom of the casing.
3. Push the visor in until an audible click is
heard.
4. The visor can now be opened and closed
in its normal function.
Adjustment
If a heavy door is fitted or if the visor will not
stay closed it may be necessary to make an
adjustment to the closing mechanism of the
visor.
Insert a small flat bladed screw driver through
the hole (the friction assembly) on either side
of the casing indicated by the letter "V" and
turn clockwise to apply pressure on the guide.
Both friction assemblies should be adjusted
by the same amount to ensure the visor opens
smoothly.
Care should be taken when removing
the visor with the decor panel for
cleaning or servicing, as the visor is now
extremely heavy and should it be dropped,
it could damage the appliance beneath
and adjoining work surfaces.
1 / ins) round headed
2
V
15