Zanussi ZB 350 Instruction Booklet page 13

Venting
The hood is more effective when used in the
extraction setting (ducted to the outside).
Venting kits may be purchased through
your retailer or DIY store, and must be
ducted to an outside vent of 100mm (4")
minimum.
The ducting used must be manufactured
from fire retardant material .
When the hood is ducted externally the
charcoal filter must be removed and the
slider control must be in the ducting position.
To Fit the Ducting
K
1. Open the grille by pressing inwardly on
the actuator bolts at each side of the
grille, while pulling the grille panel
downwards. The grille panel will slide
into the intermediate position. Raise the
lower edge of the grille forward through
45° angle until the grille becomes
detached from the slide mechanism.
2. Align the flat sides on the spigot with the
recesses in the top of the casing. Insert
and snap fix the spigot into the casing.
3. Connect the ducting to the spigot and
make an air tight seal.
4. Remove the charcoal filter and ensure the
slider control is in the ducting position.
To Remove the Charcoal Filter:
K
1. Remove the thumb screw through the
centre of the charcoal filter, from the
motor support.
2. The charcoal filter can now be removed.
Recirculation
The charcoal filter must be fitted for
recirculation and the slide control must be in
the recirculation position.
13