Zanussi ZB 350 Instruction Booklet page 14

Fitting the Cooker Hood to the Wall
K
1. Fit the brackets with the round ends
facing downwards using the plastic rawl
plugs and screws provided.
2. Once the brackets are secured, lift the
hood squarely to the wall slightly higher
than the brackets. Lower the cooker hood
until it is located onto the two brackets.
Ensure that the cooker hood is correctly
located before letting go.
3. Access to the two wall levelling screws is
from above the hood. These are located
in the two extension arms at either side of
the hood. Level the hood using the
screws located in each extension arm.
4. By loosening the screws at the front of
each extension arm the hood can be
aligned with the front of the adjoining wall
cabinets.
5. The hood should be secured on each
side to the adjoining wall cabinets using
the 4 x 15mm (
provided.
6. Adjust the lower spacer panel at the rear
of the hood to close the gap to the wall.
Decor Panel
The dimensions of the door panel should be
59.6cm (23 1 / ins) wide by 35cm (13
2
height.
Fitting a Decor Panel to the Hood Visor
K
1. Remove the complete visor assembly by
pulling open into the operating position,
simultaneously press down on the release
catch located behind the visor on the left
hand side of the casing as illustrated in
fig.2 on page 15.
2. Using the paper template provided, mark
the screw hole positions on the reverse
side of the decor panel. Ensure that the
paper template is aligned with the top
edge of the decor panel.
1 / ins) security screws
2
3 / ins) in
4
14