Pre-Installation; Location Considerations; Height Requirements; Mounting Surfaces - Trane Thermostats Installation And Operation Manual

Pre-Installation

This section provides the following pre-installation information:
•
•
•
•

Location Considerations

When selecting a location, avoid the following:
•
•
•
•
•
•
•
•
•

Height Requirements

It is recommended that you mount the back plate a maximum distance of 54 in. (137 cm) above the
floor. If a parallel approach by a person in a wheelchair is required, reduce the maximum height
to 48 inches.
Note: Consult section 4.27.3 of the 2002 Americans with Disability Act guideline, and local building

Mounting Surfaces

The thermostat can be mounted to any sturdy, vertical surface. Plastic threaded anchors and
M3.5 x 20 mm screws are provided for mounting to plaster or wallboard; 6-32 x 3/4 inch machine
screws are provided for mounting directly to a standard electrical device box. Other fastener
varieties may be required for other surface types.
When replacing a horizontally mounted thermostat and there is an adapter kit available to cover
any opening in the wall. Contact your localTrane office for more information.
BAS-SVX36C-EN
Location considerations
Height requirements
Mounting surfaces
Maximum wire length
Areas of direct sunlight
Areas in the direct airstream of air diffusers
Exterior walls and other walls that have a temperature differential between the two sides
Areas that are close to heat sources such as sunlight, appliances, concealed pipes, chimneys,
or other heat-generating equipment
Drafty areas
Dead spots behind doors, projection screens, or corners
Walls that are subject to high vibration
Areas with high humidity
High traffic areas (to reduce accidental damage or tampering)
codes, for further details regarding wheelchair requirements.
9