Pmc/Ipmc Selection Headers (J10, J15 - J18, J25 - J28); Com2 Header (J29); Table 5-18 Pmc/Ipmc Configuration Jumper Block; Table 5-19 Com2 Planar Serial Port Header (J29) Pin Assignments - Emerson MVME6100 Series Installation And Use Manual

Pin Assignments
5.3.3 PMC/IPMC Selection Headers (J10, J15 — J18, J25 — J28)
Nine 3-pin 2 mm planar headers allow for PMC/IPMC I/O selection. These nine headers can also
be combined into one single header block where a block shunt can be used as a jumper. The pin
assignments for these connectors are as follows:

Table 5-18 PMC/IPMC Configuration Jumper Block

J28
J16
J18
J25
J27
J26
J17
J10
J15
A jumper installed across pins 2 and 3 on all nine headers selects PMC1 I/O for IPMC mode.
5.3.4

COM2 Header (J29)

A 10-pin 0.100" planar header provides the interface to a second asynchronous serial debug
port. COM2 only goes to the on-board header as the default configuration. The pin
assignments for this header are as follows:

Table 5-19 COM2 Planar Serial Port Header (J29) Pin Assignments

Pin
1
3
5
98
Pin/Row 1
(PMC I/O)
PMC1_IO(2)
PMC1_IO(5)
PMC1_IO(8)
PMC1_IO(11)
PMC1_IO(14)
PMC1_IO(17)
PMC1_IO(20)
PMC1_IO(23)
PMC1_IO(26)
Signal
COM2_DCD
COM2_RX
COM2_TX
MVME6100 Single Board Computer Installation and Use (6806800D58E)
Pin/Row 2
(P2 Pins)
P2_PMC1_IO(2)
P2_PMC1_IO(5)
P2_PMC1_IO(8)
P2_PMC1_IO(11)
P2_PMC1_IO(14)
P2_PMC1_IO(17)
P2_PMC1_IO(20)
P2_PMC1_IO(23)
P2_PMC1_IO(26)
Signal
COM2_DSR
COM2_RTS
COM2_CTS
Pin/Row 3
(IPMC Pins)
IPMC DB8_L
IPMC DB9_L
IPMC DB10_L
IPMC DB11_L
IPMC DB12_L
IPMC DB13_L
IPMC DB14_L
IPMC DB15_L
IPMC DBP1_L
Pin
2
4
6