How to Play Music ...........18 • In this manual, each model name is abbreviated as How to Play Movie/Picture ........20 follows. – DNX7250DAB: DNX7 How to Listen to the DAB/ Radio ......20 – DNX5250BT, DNX525DAB: DNX5 – DNX4250DAB, DNX4250BT: DNX4 How to Make a Phone Call ........21...
• When you purchase optional accessories, check play. In such a situation, remove the disc and wait with your Kenwood dealer to make sure that they for the condensation to evaporate. If the unit still work with your model and in your area.
Ñ Acquiring GPS signal Ñ How to reset your unit The first time you turn on this unit, you must wait If the unit fails to operate properly, press the Reset while the system acquires satellite signals for the button. The unit returns to the factory settings. first time.
Neither other factors that may affect safety or timing while Kenwood nor Garmin shall be liable for problems driving. or accidents resulting from failure to observe the Use the navigation system only as a navigational aid.
Camera First Step Set the parameters for the camera. (Instruction Manual P.92) Various setup screens appear automatically before After setting, touch [6]. using. Ñ Initial setup Touch [Finish]. When you first turn on the unit, the screen of the ✎ NOTE configuration setting will appear.
Ñ iPod/iPhone connection setup Ñ Application link setup When you first select iPod as a source, the setting When you first select Apps as a source, the setting screen of the iPod/iPhone connection will appear. screen for the connection with the device installed the apps will appear.
Functions of the Buttons on the Front Panel Ñ DNX7250DAB Name/Motion Name/Motion 1 s (Reset) 6 TEL • If the unit or the connected unit fails to • Displays the Hands Free screen (Instruction operate properly, the unit returns to factory Manual P.75).
Page 9
Ñ DNX5250BT Name/Motion Name/Motion 1 Disc insert slot 8 TEL • A slot to insert a disc media. • Displays the Hands Free screen (Instruction Manual P.75). • Pressing for 1 second displays the Voice • Ejects the disc. Recognition screen. (Instruction Manual •...
Page 10
Ñ DNX525DAB Name/Motion Name/Motion 1 G (Eject) 7 Reset • Ejects the disc. • If the unit or the connected unit fails to • Pressing for 1 second ejects the disc forcibly. operate properly, the unit returns to factory settings when this button is pressed 2 MENU (Instruction Manual P.115).
Page 11
Name/Motion t SI indicator • If the Security Indicator (SI) function is turned on, this indicator flashes when the panel is detached (Instruction Manual P.86). * The display may not switch to the Graphic Equalizer screen in some conditions. English ñ...
Page 12
Ñ DNX4250DAB/ DNX4250BT Name/Motion Name/Motion 1 Disc insert slot 7 TEL • A slot to insert a disc media. • Displays the Hands Free screen (Instruction Manual P.75). 2 G (Eject) • Pressing for 1 second displays the Voice • Ejects the disc. Recognition screen.
1) Press <G> button for 1 second. faceplate and insert a SD Card The panel fully opens. 2) Hold the SD card with the label facing up, Ñ DNX7250DAB and insert it into the slot until it clicks. Detaching the faceplate Labelled side 1) Press <G>...
Page 14
Ñ DNX5250BT above. If it is detached upward, the front panel Detaching the faceplate will be broken. • To prevent deterioration, do not touch the 1) Slide the Release key upward to detach the terminals of the unit and front panel with your part of the front panel.
Page 15
Attaching the faceplate Ñ DNX525DAB Detaching the faceplate 1) Hold the panel securely so as not to drop it accidentally, and fit it onto the attaching 1) Slide the Release key rightward to detach the plate until it is firmly locked. part of the front panel.
Common Operations etc. Touch keys with various functions are displayed here. Ñ General Displayed keys differ depending on the current There are some functions which can be operated audio source, status, etc. from most screens. For examples, see List screen (P.24) in the Instruction Manual.
Garmin and JVC KENWOOD will not be responsible for any traffic fines or citations that you may receive for failing to follow all applicable traffic laws and signs.
[Where To?]. You can purchase updated map data from 2) Search for the extra stop. Garmin or ask your Kenwood dealer or 3) Touch [Go!]. Kenwood service center for details. 4) Touch [Add to Active Route] to add this stop 1) Go to www.garmin.com/Kenwood.
screen. The functions of the keys are the same despite the difference of the source you are listening to. Touch [ To eject the disc: 1) Press the <G> button. iPod/iPhone 1) Connect the iPod/iPhone. Playback starts. Basic operations from this screen ✎...
Control the movie/picture by touching the screen. Touch [Menu] on any screen. Each area on the screen has a separate function. Top Menu screen appears. Touch [DAB] (DNX7250DAB , DNX525DAB, DNX4250DAB only) or [TUNER]. The unit switches to the radio source. ñ English...
Operate on the source control screen. How to Make a Phone Call Station search for DAB You can use your Bluetooth cell-phone when paired 1) Touch [ to this unit. Sub function menu appears. ✎ NOTE • You cannot register the Bluetooth unit when you are using the following sources: iPod, Bluetooth Audio, APPS, aha Register your cell-phone to the unit.
Page 22
The selected device is connected to the unit. You can make a voice call using the voice recognition function of the cell-phone. 1) Touch [ 2) Pronounce the name registered in the cell- phone. ✎ NOTE • For detailed operation, see Using Hands-Free Unit (P.75) in the Instruction Manual.
• Insulate unconnected wires with vinyl tape or other Installation similar material. To prevent a short circuit, do not remove the caps on the ends of the unconnected Ñ Before Installation wires or the terminals. • Connect the speaker wires correctly to the terminals to Before installation of this unit, please note the which they correspond.
Page 24
If the unit is unstable, it may malfunction 3) Connect the wire on the wiring harness. (eg, the sound may skip). 4) Take Connector B on the wiring harness and Ñ Trim plate (DNX7250DAB, DNX5250BT, connect it to the speaker connector in your DNX4250DAB, DNX4250BT) vehicle.
Page 25
Ñ GPS antenna Ñ Microphone unit GPS antenna is installed inside of the car. It should 1) Check the installation position of the be installed as horizontally as possible to allow easy microphone (accessory 8). reception of the GPS satellite signals. 2) Clean the installation surface.
Page 26
Ñ Removing the trim plate (DNX7250DAB, Ñ Removing the unit (DNX7250DAB, DNX5250BT, DNX4250DAB, DNX4250BT) DNX5250BT, DNX4250DAB, DNX4250BT) 1) Engage the catch pins on the extraction key 1) Remove the trim plate by referring to step 1 in (accessory4) and remove the two locks on the “Removing the trim plate”.
Page 27
Ñ Wiring harness (Accessory 1) connector function guide Pin Numbers Cable Color Functions for ISO Connectors External Power Connector Yellow Battery Blue/White Power Control Orange/White Dimmer Ignition (ACC) Black Earth (Ground) Connection Speaker Connector Purple Rear Right (+) Purple/Black Rear Right (–) Gray Front Right (+) Gray/Black...
Ñ System connection Accessory 8 Accessory 8 Accessory 6 Accessory 6 AV Audio output AV Audio output Accessory 3 Connect to the vehicle’s Audio/Visual Accessory 2 parking brake detection Input switch harness. Visual Output Light Green (Parking sensor wire) PRK SW Rear view camera input For best safety, be sure to connect...
Ñ Connecting wires to terminals DAB antenna CX-DAB1 (Optional accessory) (DNX7250DAB, DNX525DAB, DNX4250DAB only) Fuse (10A) Fuse (10A) Accessory 1 Use of a CX-DAB1(optional accessory) as a DAB A: Black (Ground wire) antenna is recommended. B: Yellow (Battery wire) When using a commercially available DAB...
KCA-iP102 (0.8 m) When you connect the cable AV-IN (CA-C3AV; Optional Accessory) input to HDMI/MHL terminal, remove (DNX7250DAB, DNX525DAB, DNX4250DAB, DNX4250BT) the fixture. After connecting the iPod/ AV-IN2 (CA-C3AV; Optional Accessory) input cable, put the fixture again. TV tuner remote output...
VOD section in your device setup menu. Go to vod. the Bluetooth SIG, Inc. and any use of such marks by divx.com for more information on how to complete JVC KENWOOD Corporation is under license. Other your registration. trademarks and trade names are those of their •...
Page 32
Ñ Android connection • libFLAC Copyright (C) 2000,2001,2002,2003,2004,2005,2006,2 To connect the Android device with this unit, 007,2008,2009 Josh Coalson the cable (sold separately) and the profile which Redistribution and use in source and binary forms, your Android device supports are necessary as with or without modification, are permitted follows: provided that the following conditions are met:...
Page 33
Ñ Requirements Aha™: applications can be controlled from this unit. The operable functions depend on the application. Requirements for listening to Aha™ are as follows: Refer to “Apps Operation” (P.54) in the Instruction iPhone or iPod touch Manual. • Use an Apple iPhone or iPod touch running iOS4 •...
Ñ Information on Disposal of Old Electrical Ñ The marking of products using lasers and Electronic Equipment and Batteries CLASS 1 (applicable for EU countries that have adopted separate waste collection LASER PRODUCT systems) Products and batteries with the symbol (crossed-out The label is attached to the chassis/case and says wheeled bin) cannot be disposed as household waste.
Page 35
Sellega kinnitab JVC KENWOOD, et see DNX7250DAB, DNX5250BT, DNX525DAB, Español DNX4250DAB, DNX4250BT vastab direktiivi 1999/5/EC põhilistele nõudmistele ja Por medio de la presente JVC KENWOOD declara que el DNX7250DAB, DNX5250BT, muudele asjakohastele määrustele. DNX525DAB, DNX4250DAB, DNX4250BT cumple con los requisitos esenciales y Latviešu...