Table of Contents
Advertisement
User Manual
8. When you see the following message (or similar depending on which version of Windows
you are using) the installation has completed and you may proceed to install the next
computer.
9. Repeat steps 6, 7 and 8 for each computer you want to connect.
Mac OS & Linux
The AutoSwitch can only be used in manual mode with USB enabled versions of Mac OS and
Linux so no software installation is required. Simply connect the AutoSwitch to each computer
using a USB A to B cable and allow the computer to recognise and install the hardware. Repeat
this for each computer which you want to connect.
Operation
Connect a USB device to the USB port on the front of the AutoSwitch, the example below
shows a printer connected to the AutoSwitch.
After installing the software (as outlined earlier) an icon will
have been added to your system tray. This icon shows you the
status of the AutoSwitch and also allows you to set the idle
time between switches.
Available (AutoSwitch is idle, no jobs pending)
Occupied by you (you are already in control of the AutoSwitch!)
Occupied (AutoSwitch is in use by another computer)
4
English
Advertisement
Table of Contents
