Duracell POWERPACK 600 Owner's Manual page 40

Recharging the Duracell® Powerpack 600 Battery
l'
WARNING: Fire and explosion hazard
~
Do not use this recharging method if your vehicle has abnormally
high voltage electrical systems that operate above 15 V DC. This
may lead to accumulations of hydrogen, causing exposure to fire
and explosion hazard.
l'
CAUTION
~
Do not operate AC or DC appliances while the Duracell®
Powerpack is being recharged with the DC charging cable from
your vehicle.
To recharge the Duracell® Powerpack while you drive
using the DC charging cable:
1. While the vehicle engine is running, plug one end of the
DC charging cable into the DC power socket of the
Duracell® Powerpack.
2. Plug the opposite end of the DC charging cable into the
vehicle's lighter socket or 12 V accessory outlet.
3. Once the Duracell® Powerpack is fully charged or if
your vehicle's engine is not running, disconnect the DC
charging cable from both sockets.
Most of the capacity will be restored in four hours while
the vehicle engine is running.
Note: The green Charging Status light will not illuminate when
the Duracell® Powerpack is recharged through the DC charging
cable.
Note: Battery Charge
(%)
indicator is only accurate when the
Duracell® Powerpack has been disconnected from all appliances
and all charging sources for 15 minutes.
Important: Do not leave the Duracell® Powerpack permanently
connected to the vehicle's lighter socket or 12 V accessory
outlet~
975-0339-01-01
29