Installation; Preparing For Intellectual Stack - Hitachi CP-X8150 User Manual

2. Installation

For safety reasons, read
before installation. In addition, take note of the followings for proper use of Instant
Stack.
● When using Intellectual Stack, both projectors will respond to the remote control
signals until STACK MODE on either projector is set to SUB.
If you control one projector with the remote control during installation, it is
recommended to operate the other with the control panel or a wired remote
control. In this case, disable the remote control receiving on the other projector
with the KEY LOCK feature.
● Images from Set A and Set B may superimpose well but the image positions
can shift over time.
Readjust to superimpose the images.

2.1 Preparing for Intellectual Stack

When using Intellectual Stack via RS-232C connection, ensure the following set-
tings are set on the two projectors. Otherwise, the Intellectual Stack menu cannot
be operated.
● STANDBY MODE in SETUP menu: NORMAL
(Operating Guide
● COMMUNICATION TYPE under COMMUNICATION in SERVICE menu: OFF
(Operating Guide
● STACK LOCK in SECURITY menu: OFF
When STACK LOCK is set to on, menus related to Instant Stack cannot be
operated. It is therefore necessary to set it to off during installation and menu
setting.
(1) Use the ▲/▼/◄/► buttons to go into the following menu.
ADVANCED MENU > SECURITY
> STACK LOCK
STACK LOCK dialog will appear on screen.
Guide → SECURITY
(2) Use the ▲/▼ buttons to highlight OFF, and press the ► button to complete
the setting.
1.1 Basic information and preparations
(Operating Guide
→ SETUP menu)
→ OPTION menu)
menu)
→ OPTION
(Operating
5
( 3, 4 ) carefully
menu)